[ View Full Version Of This Page ]

Fuel Gauge doesnt work!?

All Forums » V6 Tech » Fuel Gauge doesnt work!?

Camaro 2.8
8/20/2007 11:00:59 PM
My fuel gauge doesnt work and I just bought my camaro recently and I need to fix it but I dont know how. Can anyone help me plz? My car is a 1984 2.8l V6 
zeus8807
8/21/2007 9:51:36 AM
u need to check to make sure the guage is getting power to it, if it is it could be the guage, their pretty simple to replace
MadMikeZ28
8/21/2007 12:51:19 PM
There is a pink wire that goes from the gauge to the sender. The sender opperates on a ground by sending different resistances. Locate the pink wire. It may be easier to just tap into it rather than pull it off the sender since its a pain to get the tank down. If I remember the wires will be under the corpet on the drivers side. Pull the sill plate and lift the carpet to see. Tap into the pink wire and ground it with the key on and see if the gauge moves. If it moves then you either have a bad sender or a break in the wire between the tapped point. You could also have a bad ground on the sender. 
Camaro 2.8
8/21/2007 10:23:55 PM
Ok cool thanks I going to try it 2mrw b4 I go to work hope fully it works. I dont know know how much gas I have in it. I filled it up and drove it around 120 miles. 
MadMikeZ28
8/22/2007 12:23:22 AM
quote:

ORIGINAL: Camaro 2.8

Ok cool thanks I going to try it 2mrw b4 I go to work hope fully it works. I dont know know how much gas I have in it. I filled it up and drove it around 120 miles

Fill it up again.
You should get more of a range out of it but it depends on your driving style on how much. Fill it and see how much you used. Its  a 15 gallon tank.
Related Threads

[ View Full Version Of This Page ]

Return to the Camaro Forums home page - Archive Home