73 T Top
5/8/2007 7:57:19 PM
I just got my drive shaft shortened 3 inches to fit with the 700R4 transmission. I got it home and started putting it back on when I found out that my drive shaft doesnt fit with the 700R4 (the length is right but they dont connect right). The 73' camaro did have a muncie m20 in it (the guy told me it had a 3/4" countershaft, whatever that means).
If I took the end spline piece from the muncie would it spline and fit in the 700R4? The transmission is at my school and I cant check if it does right now.
If not, what else could I do?
microkid
5/8/2007 9:58:09 PM
not sure how it works, but can you change just the front part of the driveshaft? its going to be a different amount of splines. and why did you go with a 700r4 and no a th350 or th400?
73 T Top
5/8/2007 10:46:13 PM
the 700R4 was already attached to the 350 TBI that im putting in. im not sure if you can change the end of the drive shaft. from what I remember, it was welded.
this is the first serious problem that I have ran into, everything else has been pretty simple
73 T Top
5/8/2007 10:50:35 PM
also, would the drive shaft for an automatic 73' camaro be shorter then a manual?
73 T Top
5/10/2007 3:45:28 PM
ok, i got the yoke from the muncie yesterday and it matched exactly as the one on the 700R4. that problem solved!!!
