Z28midwest_08
Posts: 20
Score: 0
Joined: 11/21/2007
Status: offline
|
Ok so this is going to be a dumb question, I think, but I can''t get it. I have an 82 Z28 and it''s lifted high enough cause I was going to drop it in favor or a TH 350. I have all the bolts out of the bellhousing accept for the 2nd on on the passenger side, right by the starter. I''ve tried wrenches and if I get any room it just slips, i''ve tried 1/4 inch ratchets and they have no torque. The weird part is it doesn''t seem round but the tightest fit is actually a 14mm. I''ve also tried from the top too and I have no room. Has anyone pulled this tranny (200C) by not removing the motor and has advice for the sticky last bolt. Oh, also tried WD40, didn''t do it either.
|
Printable Version
Transmission removal - 
